Features:
*You will get 1 set of DIY clock parts for clock panels with 35-40cm diameter.
*These clock repair replacement parts are suitable for cross-stitch, three-dimensional embroidery, craft clocks, frameless pull clocks, and especially suitable as replacement parts for DIY quartz wall clocks.
*This product is accurate timing, time error within 1 for second, service life of up to 3 years, low power consumption, very environmentally friendly, ordinary batteries can be used for 6 months.
*This movement uses 1 section of 1.5V-AA batteries(carbon batteries can be used, alkaline batteries are not recommended, otherwise the current is too high, affecting the time, delivery without batteries)
*This product is suitable for craft clocks, wooden wall clocks, metal wall clocks, electric box wall clocks, porcelain for crystal paintings, repair and replacement, DIY home decorative clocks; it can rejuvenate your old clocks and make your new DIY crafts more perfect.
*No ticking sound, only the sweep of the second hand instead of ticking, making the movement more quiet.
Details:
Material: plastic, metal
Color: black, black-red, black second hand point
Dimensions:
Movement dimensions:
Movement specifications:
56*56*16mm, shaft length 18mm, thread height 11mm, suitable for 5-8mm thick clock panels.
56*56*16mm, shaft length 28mm, thread height 21mm, for 12-17mm thick clock panels.
56*56*16mm, shaft length 31mm, thread height 24mm, for 19-21mm thick clock panels.
Dimensions of hands:
Hour hand(measured from the round hole to the top): 90mm
Minute hand(measured from the round hole to the top): 130mm
Seconds hand(measured from the round hole to the top): 133 mm
Applications: for 35-40cm cm diameter clock panels
Battery: 1 x 1.5V-AA battery(battery not included in delivery)
Package contents:
Delivery list: clock movement, hands, accessories.
Caution:
1. Due to various factors, such as monitor brightness, light brightness, etc., the actual color of the product may be slightly different from the picture on the website.
2. 2. Please allow slight manual measurement deviation in the data.
3. 3. Please refer to the installation diagram of the pointer to understand how to install the pointer.
4. 4. After the three pins are installed, the three pins should be parallel when viewed from the side, and it is best not to touch the pins.
